Lifeboat Foundation: Safeguarding Humanity
Toggle light / dark theme

Blog

Category: electronics

Step aside, Nikon P1000, the new king of zoom is here. It’s an electronic microscope, though, but it can zoom in 100 million times and still keep the subject clear. It’s so impressive, in fact, that it earned a spot in the Guinness World Records.

Although electron microscopes allow scientists to see individual atoms, zooming all that far will not result in a sufficiently clear image. It’s due to the aberrations in the lenses which are corrected with special aberration correctors. But the problem is that you can’t stack those correctors forever.

David Muller and Sol Gruner, physics professors of Cornell University, came up with a new approach that they first introduced back in 2018. Their electron microscope achieves high resolution using a high-powered detector and a technique called ptychography. Thanks to this technique, they could capture in sharp detail even particles that measure down to 0.39 ångströms or 0.039 nanometers (one-billionth of a meter).

Read more | >

Seagate has been working toward developing a dual-actuator hard drive, meaning that the drive will contain two sets of independently controlled read/write heads. Now, after several years, the company has released its first functional dual-actuator hard drive, the Mach.2. Currently, only enterprises can purchase and use this product, meaning that at least for now, end users will have to wait their turn.

So far, Seagate has reported the Mach.2’s sequential, sustained transfer rate as up to 524MBps—over double the rate of a fast but generic rust disk, closer to the capacity seen in SATA SSD. In fact, this increased carries over into input/output as well, featuring 304 IOPS read / 384 IOPS write and only 4.16 ms average latency. By contrast, normal hard drives usually run at 100/150 IOPS with about the same average latency.

Of course, all of that extra capacity requires additional power. Even while idle, the Mach.2 runs at 7.2 W, while Seagate’s standard Ironwolf line runs at 5 W while idle. That said, it is a bit easier to measure the power specs of Mach.2 than Ironwolf, as the former’s power use can be determined using several random input/output scenarios, as opposed to Ironwolf, whose power is gauged from its “average operating power,” a metric undefined by the Seagate data sheet reference.

Read more | >

Circa 2010

In a laboratory 10 miles east of downtown Los Angeles, a mechanical penis sputters to life. A technician starts a timer as a stream of water erupts from the apparatus’s brass tip, arcing into a urinal mounted exactly 12 inches away. James Krug smiles. His latest back-splatter experiment is under way.

Krug is an unusual entrepreneur. Twenty years ago, he was a rising star in the film and television business. He served as a vice president of the Disney Channel in the 1980s and ran a distribution company with members of the Disney family in the ’90s. But 11 years ago, Krug became convinced that the world did not need another TV show. What it needed was a better urinal.

Read more | >

Over the past decade or so, the semimetal graphene has attracted substantial interest among electronics engineers due to its many advantageous qualities and characteristics. In fact, its high electron mobility, flexibility and stability make it particularly desirable for the development of next-generation electronics.

Despite its advantageous properties, large-area has a zero bandgap (i.e., the energy range in solid materials at which no electronic states can exist). This means that in graphene cannot be completely shut off. This characteristic makes it unsuitable for the development of many electronic devices.

Researchers at Tsinghua University in China recently devised a design strategy that could be used to attain a larger bandgap in graphene. This strategy, introduced in a paper published in Nature Electronics, entails the use of an electric field to control conductor-to-insulator transitions in microscale graphene.

Read more | >

There has not been enough progress in our understanding of the basic mechanisms underlying psychosis. Studying psychotic disorders in animal models is difficult because the diagnosis relies on self-reported symptoms that can only be assessed in humans. Schmack et al. developed a paradigm to probe and rigorously measure experimentally controlled hallucinations in rodents (see the Perspective by Matamales). Using dopamine-sensor measurements and circuit and pharmacological manipulations, they demonstrated a brain circuit link between excessive dopamine and hallucination-like experience. This could potentially be useful as a translational model of common psychotic symptoms described in various psychiatric disorders. It may also help in the development of new therapeutic approaches based on anatomically selective modulation of dopamine function.

Science, this issue p. see also p. [33][2]

### INTRODUCTION

Read more | >

An interview with Dr. Yulia Turchaninova on What would be your take on that?

Many parents employ a “job” metaphor for school. But as a parent, do you bring your work home every night? Do it over the weekend? Take it with you on vacation? And if you do, are you still eager to work on it when the whole family sits down to chat, play and watch TV after dinner? And how many direct bosses do you have above you? How about six to eight different ones a day, each with their own quirks? Do they replace each other at the ring of the bell, demanding that you instantly and completely switch to the new assignment, regardless of whether you have completed the previous one, and do it in their idiosyncratic way? And if you do, is this the kind of life that you would wish for your children?

Brodsky: So, what would be a better way of treating our metaphors?

Turchaninova: Since metaphors shape our understanding of complex issues, it may be wise for parents and educators to reflect on the metaphors we use while talking about school. It would be great for us as a society to come up with a new set of metaphors that help us express the essence of the kind of education we want for our children in the upcoming century.

Read more | >

A team from Georgia Tech has just announced a world-first: a 3D-printed rectifying antenna the size of a playing card that can harvest electromagnetic energy from 5G signals and use it to power devices, turning 5G networks into wireless power grids.

Wireless communications put a lot of energy into the air, and over the years we’ve covered a number of efforts to harvest that energy. Short-range Wi-Fi signals have been the target of several projects, TV broadcasts and radio signals have been the focus of others. One device even hopes to increase the life of a smartphone’s battery by 30 percent just by harvesting some of the radio waves the phone itself is generating.

But 5G communications offer a whole new opportunity. 5G has been designed for blazing fast and low-latency communications, reads the Georgia Tech team’s latest study, published in the peer-reviewed journal Scientific Reports. To do so, mm-wave frequencies were adopted and allowed unprecedently high radiated power densities by the FCC. Unknowingly, the architects of 5G have, thereby, created a wireless power grid capable of powering devices at ranges far exceeding the capabilities of any existing technologies.

Read more | >